Buick Regal: Using the Digit Dial Command
1. Press
.
2. Say “Digit Dial.” The system responds “Digit dial using <phone name>, please say the first digit to dial,” followed by a tone.
3. Say the digits to be dialed one at a time. The system repeats back the digit it heard followed by a tone.
4. Continue entering digits until the number to be dialed is complete.
After the entire number has been entered, say “Dial.” The system responds “OK, Dialing” and dials the number.
► If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number. ► To hear all of the numbers recognized by the system, say “Verify” at any time.
Using the Dial Command
1. Press
.
► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.
► For vehicles with a navigation system, the system responds with a tone. Aft ...
Using the Call Command
1. Press
.
► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.
► For vehicles with a navigation system, the system responds with a tone. Aft ...
See also:
Safety belts
Seats with safety belt
The vehicle has five seats, each of which is
equipped with a safety belt.
Notes
Always make sure that safety belts are being
worn by all occupants before driving away.
A ...
Introduction
The park assist system is designed to assist you when driving into parking spaces,
garages, etc. It utilizes ultrasound sensors in the front bumper and rear bumper(s)
to measure the distance to a ...
Turn signal switch
Turn signal
1 Move the lever up or down to signal the
turning direction. When the turn is completed,
the turn signals cancel automatically.
Lane change signal
2 To signal a lane change, move th ...