Buick Regal: Using the Re-dial Command - Bluetooth (Voice Recognition) - Phone - Infotainment System - Buick Regal Owners ManualBuick Regal: Using the Re-dial Command

1. Press ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone..

► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.

► For vehicles with a navigation system, the system responds with a tone. After the tone, say

Hands Free.” The system responds “Ready,” followed by a tone.

2. After the tone, say “Re-dial.” The system responds “Re-dial using <phone name>” and dials the last number called from the connected Bluetooth phone.

Once connected, the person called will be heard through the audio speakers.

    Using the Call Command
    1. Press . ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone. ► For vehicles with a navigation system, the system responds with a tone. Aft ...

    Receiving a Call
    When an incoming call is received, the audio system mutes and a ring tone is heard in the vehicle. ► Press . ► Press to ignore a call. ...

    See also:

    Warning lights
    For additional information on warnings and indicators, see Vehicle information display later in this section.  Anti-lock Braking System (ABS) warning light When the ignition switch is pla ...

    AM
    The range for most AM stations is greater than for FM, especially at night. The longer range can cause station frequencies to interfere with each other. For better radio reception, most AM r ...

    System alarm operation
    The alarm system will give the following alarms when triggered: ● The vehicle’s horn will sound and the turn signal lights will flash for 30 seconds. ● If any door (or the rear gate/ ...