Chrysler 200: Voice Training
For users experiencing difficulty with the system recognizing their voice commands or numbers, the Uconnect™ Phone Voice Training feature may be used. To enter this training mode, follow one of the two following procedures:
From outside the Uconnect™ Phone mode (e.g., from radio mode):
• Press and hold the button for five seconds until the session begins, or, • Press the button and say the “Voice Training, System Training, or Start Voice Training” command.
You can either press the Uconnect™ Phone button to restore the factory setting or repeat the words and phrases when prompted by the Uconnect™ Phone. For best results, the Voice Training session should be completed when the vehicle is parked with the engine running, all windows closed, and the blower fan switched off.
This procedure may be repeated with a new user. The system will adapt to the last trained voice only.
Uconnect™ Phone Tutorial
To hear a brief tutorial of the system features, press the button and say “Uconnect™ Tutorial.” ...Reset
• press the button. • After the “Ready” prompt, and the following beep, say “Setup”, then “Reset”. This will delete all phone pairing, phone book entries, and other settings in ...See also:
Instrument panel vents
The outlet vents can be opened or closed separately using the thumbwheel.
Also, you can adjust the direction of air delivered from these vents using the
vent control lever as shown. ...
Three-Way Calling
Three-way calling must be
supported on the cell phone and
enabled by the wireless service
carrier.
1. While on a call, press .
2. Say “Three-way call.”.
3. Use the dial or call command to ...
Storing a Flat or Spare Tire
and Tools
WARNING!
Storing a jack, a tire, or other
equipment in the passenger
compartment of the vehicle could
cause injury. In a sudden stop or
collision, loose equipment could
strike someone. Stor ...