Chrysler 200: Windshield Washers
To use the washer, pull the windshield wiper/washer control lever toward you and hold it for as long as washer spray is desired.
If you activate the washer while the wiper control is in the delay range, the wipers will operate in low-speed for two wipe cycles after releasing the lever and then resume the intermittent interval previously selected.
If you activate the washer while the wiper control is in the off position, the wipers will operate for two wipe cycles and then turn off.
WARNING!
Sudden loss of visibility through the windshield
could lead to a collision. You might not see other
vehicles or other obstacles. To avoid sudden icing of
the windshield during freezing weather, warm the
windshield with defroster before and during windshield
washer use.
Intermittent Wiper System
Use the intermittent wiper system when weather conditions make a single wiping cycle with a variable pause between cycles desirable. Rotate the end of the windshield wiper/washer control lever t ...Mist Feature
Push down on the wiper control lever to activate a single wipe to clear the windshield of road mist or spray from a passing vehicle. As long as the lever is held down, the wipers will continue t ...See also:
Adjusting the set speed
To change the set speed, operate the lever until the desired set
speed is obtained.
1 Increases the speed
2 Decreases the speed
Fine adjustment: Momentarily
move the lever in the desired
di ...
Uconnect™ Phone — if equipped
Uconnect™ Phone is a hands-free system that allows youto use voice commands to
dial a phone number storedin your cellular phone. Press the Uconnect™ Phonebutton
on the radio or steering wheel c ...
To Stop Playing Your iPod
To play the radio, press the FM/AM,
or button. Press the CD button
to switch to the disc mode. Press the
AUX button to switch back to the
iPod.
Disconnecting an iPod
You can disconnect the ...