Buick LaCrosse: Wiper Blade Replacement - Vehicle Checks - Vehicle Care - Buick LaCrosse Owners ManualBuick LaCrosse: Wiper Blade Replacement

Windshield wiper blades should be inspected for wear and cracking.

See Maintenance Schedule for more information.

Replacement blades come in different types and are removed in different ways. For proper type and length, see Maintenance Replacement Parts.

To replace the windshield wiper blade:

1. Pull the windshield wiper assembly away from the windshield.

2. Lift up on the latch in the middle

2. Lift up on the latch in the middle of the wiper blade where the wiper arm attaches.

3. With the latch open, pull the wiper blade down toward the windshield far enough to release it from the J-hooked end of the wiper arm.

4. Remove the wiper blade.

Allowing the wiper blade arm to touch the windshield when no wiper blade is installed could damage the windshield. Any damage that occurs would not be covered by the vehicle warranty. Do not allow the wiper blade to touch the windshield.

5. Reverse Steps 1 through 3 for wiper blade replacement.

    Park Brake and P (Park) Mechanism Check
    WARNING! When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case ...

    Headlamp Aiming
    The headlamp aiming system has been preset at the factory. If the vehicle is damaged in an accident, the aim of the headlamps may be affected and adjustment may be necessary. It is recommend ...

    See also:

    Transmission position and drive program display
    The current transmission position and drive program appear in the multifunction display. 1. Transmission position display 2. Drive program display The arrows in the transmission position d ...

    Maintenance schedule
    The oil change indicator system will remind you that it istime to take your vehicle in for scheduled maintenance. On Electronic Vehicle Information Center (EVIC)equipped vehicles “Oil Change Re ...

    Headlamp High/Low-Beam Changer
    (Headlamp High/Low-Beam Changer): Push the turn signal/lane change lever away from you and release, to turn the high beams on. To return to low beams, push the lever again or pull it toward y ...