Subaru Legacy: A/C – Air conditioner button
If the windshield starts to fog when the climate control system is operated in the AUTO mode, press the air conditioner button “A/C” to defog and dehumidify. When this button is pressed, the air conditioner compressor turns on and the indicator light “A/C” on the display illuminates.
To turn off the air conditioner compressor, press the “A/C” button again.
NOTE
The air conditioner compressor does not operate when the outside air temperature is below 328F (08C).
Fan speed control button
The fan speed control button has 6 different fan speed positions. The fan speed is shown by the display. ...Airflow mode selection button
Select the desired airflow mode by pressing the airflow mode selection button. The selected airflow mode is shown on the display. There are four airflow modes that activate the following air outl ...See also:
How to speak numbers
Voice Recognition requires a certain way to
speak numbers when giving voice commands.
Refer to the following examples.
General rule:
● Only single digits 0 (zero) to 9 can be used.
● ...
Rear window wiper and washers
Intermittent wiping
Pull the lever towards the steering wheel.
Reverse gear wipe
The rear wiper will be activatedautomatically when selecting reverse gear, if
• the rear wiper is not already swi ...
Brake/clutch fluid
Check brake fluid level in the brake fluid reservoir. The level should be between
“MIN” and “MAX” marks on the side of the reservoir. Use only hydraulic brake fluid
conforming to DOT 3 or ...