Honda Accord: Accessory Power Sockets
Your vehicle has two accessory power sockets; one is at the front of the center console and the other is in the console compartment.
To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.
Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).
None of the sockets will power an automotive type cigarette lighter element.
Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.
Console Compartment
To open the console compartment,
pull up on the lever and lift the
armrest.
To close, lower the armrest, and
push it down until it latches. ...
Sun Visor
To use the sun visor, pull it down.
When using the sun visor for the
side window, remove the support rod
from the clip, and swing it out.
In this position, the sun visor can be
adjusted by m ...
See also:
Driver’s SRS frontal airbag
The driver’s SRS frontal airbag uses a dual stage inflator. The inflator operates
in different ways depending on the severity of impact.
Have the system inspected by your SUBARU dealer immediatel ...
Low-beam headlamps
•► To switch on the low-beam headlamps:
turn the SmartKey in the ignition lock to
position 2 or start the engine.
•► Turn the light switch to .
The indicator lamp in the instrume ...
Checking the fluid level
WARNING
● Never let brake fluid contact your eyes because brake fluid can be harmful
to your eyes. If brake fluid gets in your eyes, immediately flush them thoroughly
with clean water. For ...