Subaru Legacy: Alarm system
It blinks to show the driver the operational status of the alarm system. For detailed information, refer to “Alarm system” F2- 15.
Security indicator light
This indicator light shows the status of the alarm system. It also indicates operation of the immobilizer system. ...Immobilizer system
This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to ...See also:
Closing the trunk
To close the trunk, lower the trunk lid, then press down on it until it locks.
To be sure the trunk lid is securely fastened, always check by trying to pull it
up again.
WARNING
The trunk lid sh ...
Recommended Fuel
If the vehicle has a 2.4L L4 engine (VIN Code C), use regular unleaded gasoline with a posted octane rating of 87 or higher. If the octane rating is less than 87, an audible knocking noise, commonly r ...
Rear seat armrest
Activity console
Installing the activity console
1. Remove the centre seat cusion.
2. Install the activity console.
Removing the activity console
1. Pull the handle and remove the activitycon ...