Subaru Legacy: AT OIL TEMP warning light (AT and CVT models) - Warning and indicator lights - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: AT OIL TEMP warning light (AT and CVT models)

The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. If this light illuminates when the engine is running, it may indicate that the transmission fluid temperature is too hot. If the light illuminates while driving, immediately stop the vehicle in a safe place and let the engine idle until the warning light turns off.

Engine low oil level warning light
The engine low oil level warning light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. This light also illuminates when the en ...

Transmission control system warning
If the “AT OIL TEMP” warning light flashes after the engine has started, it may indicate that the transmission control system is not working properly. Contact your nearest SUBARU dealer for se ...

See also:

Power outlet
Instrument panel The power outlets are for powering electrical accessories such as cellular telephones. They are rated at 12 volt, 120W (10A) maximum. The console outlet is powered directly by t ...

Wheel selection
When replacing wheels, care should be taken to ensure that they are equivalent to those removed in load capacity, diameter, rim width, and inset*. Replacement wheels are available at your Toyota ...

Changing a Flat Tire
NOTE: If the following occurs while driving, it could indicate a flat tire. - Steering becomes difficult. - The vehicle begins to vibrate excessively. - The vehicle pulls in one direction. If you ...