Nissan Altima: Auto-reverse function
If the control unit detects something caught in the window as it is closing, the window will be immediately lowered.
The auto-reverse function can be activated when the window is closed by automatic operation when the ignition switch is placed in the ON position or for 45 seconds after the ignition switch is placed in the OFF position. Depending on the environment or driving conditions, the auto-reverse function may be activated if an impact or load similar to something being caught in the window occurs.
WARNING
There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window.
Automatic operation
To fully open a window equipped with automatic
operation, press the window switch down (only
driver’s side shown) to the second detent and
release it; it need not be held. The window automatica ...
Moonroof
When power window switch does not
operate
If the power window automatic function (closing
only) does not operate properly, perform the following
procedure to initialize the power window
system:
...
See also:
Battery-saving function
In order to prevent the vehicle battery from discharging, if the headlights
and/or tail lights are on when the engine switch is turned to the “LOCK”
position
(vehicles without a smart key sy ...
Maintenance precautions
When performing any inspection or maintenance
work on your vehicle, always take care to prevent
serious accidental injury to yourself or damage to
the vehicle. The following are general precautions ...
Audible signal
The Park Assist system uses an intermittent tone that pulses faster as you come
close to an object, and becomes constant when you are within approximately 1 ft
(30 cm) of an object in front of or ...