Chrysler 200: Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage before you begin programming.
For more efficient programming and accurate transmission of the radio-frequency signal it is recommended that a new battery be placed in the hand-held transmitter of the device that is being programmed to the HomeLink system.
Erase all channels before you begin programming. To erase the channels place the ignition in the ON/RUN position and press and hold the two outside HomeLink buttons (I and III) for up 20 seconds or until the red indicator flashes.
NOTE:
• Erasing all channels should only be performed when
programming HomeLink for the first time. Do not
erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–3515 or, on the Internet at www.HomeLink.com for information or assistance.
Garage Door Opener — If Equipped
HomeLink replaces up to three hand-held transmitters
that operate devices such as garage door openers, motorized
gates, lighting or home security systems. The
HomeLink unit is powered by your ve ...
Programming A Rolling Code
For programming garage door openers that were manufactured
after 1995. These garage door openers can be
identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is a ...
See also:
Function
After the safety belt is buckled and the door is
closed, the front belts are automatically tightened
once after the vehicle is driven is away.
In critical driving situations, the following indivi ...
Wheels and tires
Vehicle equipment
All standard, country-specific and optional
equipment that is offered in the model series is
described in this chapter. Therefore, equipment
is also described that is not avai ...
Tire chains
CAUTION
Tire chains cannot be used on any tires for your Legacy and Outback because of
lack of clearance between the tires and vehicle body. ...