Subaru Legacy: Combination meter illumination
When the ignition switch is turned to the “ON” position, the various parts of the combination meter are illuminated in the following sequence.
1. Warning lights, indicator lights, meter needles, gauge needles, odometer and
trip meter back light illuminate.
2. Meter needles and gauge needles each show MAX position.
3. Meter needles and gauge needles each show MIN position.
4. Dials and indicators in meters and gauges light up.
5. Regular illumination (for driving) begins.
NOTE
The above sequence of operations may not take place if you quickly turn the ignition switch to start the engine. This is not a malfunction.
Meters and gauges
NOTE
Liquid crystal displays are used in some of the meters and gauges in the combination
meter. You will find their indications hard to see if you wear polarized glasses. ...
Canceling the function for meter/gauge needle movement upon turning on the ignition
switch
It is possible to activate or deactivate the movement of the meter needles and
gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition swi ...
See also:
Difference between predicted and actual
distances
The distance guide line and the vehicle width
guide line should be used as a reference only
when the vehicle is on a level, paved surface. The
distance viewed on the monitor is for reference
only ...
Blind Spot Information System*
Introduction
1 - BLIS camera 2 - Indicator light 3 - BLIS symbol
The Blind Spot Information System (BLIS) is an information system that indicates
the presence of another vehicle moving in the ...
Outside rear view mirrors
Mirror angle can be adjusted using the switch.
To select a mirror to adjust,
press the switch.
1 Left
2 Right
To adjust the mirror, press the
switch.
1 Up
2 Right
3 Down
4 Left
Fold ...
