Subaru Legacy: Compass calibration
1. If a “C” is displayed in the compass window, the compass needs to be calibrated.
2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads
a direction.
3. You can also calibrate the compass by driving your vehicle on your everyday routine.
The compass will be calibrated once it has tracked a complete circle.
4. To recalibrate your compass, push and hold the switch for 9 seconds until a “C”
appears in the compass window.
5. Calibrate the compass according to step 2 or step 3.
Compass zone adjustment
Compass calibration zones 1. Refer to the “Compass calibration zones” map shown above to verify that the compass zone setting is correct for your geographical location. 2. Press and hold the ...Auto-dimming mirror with compass and HomeLink® (if equipped)
1) HomeLink® button 1 2) HomeLink® button 2 3) LED 4) HomeLink® button 3 5) Sensor 6) Automatic dimming on/off button 7) Compass display button 8) Compass display The auto-dimming mirror ...See also:
Installing a booster seat
WARNING
● Child restraint systems and seatbelts can become hot in a vehicle that has
been closed up in sunny weather; they could burn a small child. Check the child
restraint system before ...
The concept
Two radar sensors below the rear bumper monitor
the area behind and next to the vehicle at
speeds above approx. 30 mph/50 km/h.
The system indicates whether there are vehicles
in the blind sp ...
Search
The keypad in the center console can be used to search for a file in the currently
selected folder.
Start the search by either turning TUNE (to access the folders) or by pressing
one of the chara ...