Hyundai Sonata: Emission control system - Maintenance - Hyundai Sonata Owners ManualHyundai Sonata: Emission control system

The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Owner’s Handbook & Warranty Information booklet in your vehicle.

Your vehicle is equipped with an emission control system to meet all applicable emission regulations.

There are three emission control systems, as follows.

(1) Crankcase emission control system
(2) Evaporative emission control system
(3) Exhaust emission control system

In order to assure the proper function of the emission control systems, it is recommended that you have your car inspected and maintained by an authorized HYUNDAI dealer in accordance with the maintenance schedule in this manual.

Caution for the Inspection and Maintenance Test (With Electronic Stability Control (ESC) system)

• To prevent the vehicle from misfiring during dynamometer testing, turn the Electronic Stability Control (ESC) system off by pressing the ESC switch.
• After dynamometer testing is completed, turn the ESC system back on by pressing the ESC switch again.

Interior care
Interior general precautions Prevent caustic solutions such as perfume and cosmetic oil from contacting the dashboard because they may cause damage or discoloration. If they do contact the dashbo ...

1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase. This system supplies fresh filtered air to the crankcase th ...

See also:

To Arm The System
1. Remove the keys from the ignition switch and get out of the vehicle. 2. Lock the door using either the power door lock switch (one door must be open) or the LOCK button on the Remote Keyless ...

Ashtray
An ashtray can be installed in the cup holder. CAUTION ■When not in use Keep the ashtray closed. In the event of sudden braking, an accident may occur due to an occupant being struck b ...

Calling up a stored setting
•► Press and hold the relevant storage position button 1, 2 or 3 until the seat, steering wheel and exterior mirrors are in the stored position. The setting procedure is interrupted as ...