Dodge Avenger: Engine block heater — if equipped
The engine block heater warms the engine, and permitsquicker starts in cold weather. Connect the cord to astandard 110-115 Volt AC electrical outlet with agrounded, three-wire extension cord.
The engine block heater cord is bundled under the hoodbetween the headlight assembly and the Totally IntegratedPower Module (Fuse Box) on the driver’s side ofthe vehicle.
WARNING:
Remember to disconnect the cord before driving.
Damage to the 110-115 Volt electrical cord could causeelectrocution.
Starting procedures
Before starting your vehicle, adjust your seat, adjust theinside and outside
mirrors, fasten your seat belt, and ifpresent, instruct all other occupants to buckle
their seatbelts.
WARNING:
Never ...
Automatic transmission
CAUTION:
Damage to the transmission may occur if the followingprecautions are not observed:
• Shift into PARK only after the vehicle has come toa complete stop.
• Shift into or out of REVERSE o ...
See also:
Tether anchorage location
Legacy
Three tether anchorages are installed on the rear shelf behind the rear seat
head restraint. Open the cover flap to use each anchorage.
Outback
Three tether anchorages, i.e., ones for ...
Manual Compass Calibration
If the compass appears erratic or inaccurate, and the
variance has been properly set, you may wish to manually
recalibrate the compass. To manually calibrate the
compass:
1. Start the engine. L ...
Window antenna
The antenna pattern is printed inside the rear
window.
CAUTION
● Do not place metalized film near the
rear window glass or attach any metal
parts to it. This may cause poor reception
or no ...