Subaru Legacy: Front turn signal light
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary.
1. Turn over the protective cover of the engine compartment.
2. Turn the socket counterclockwise and pull it out.
3. Pull out the bulb from the socket and replace the bulb with a new one.
4. After replacing the bulbs, reposition the protective cover of the engine compartment.
High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the air intake duct, refer to “Removing air intake duct” F11-7. Left-hand side 2. Use a screwdriver to remove the se ...Front position light
1. Turn the socket counterclockwise and pull it out. 2. Pull out the bulb from the socket and replace the bulb with a new one. ...See also:
Arming and disarming the alarm
system
General information
When you lock or unlock the vehicle, either with
the remote control, Comfort Access or at the
door lock the alarm system is armed or disarmed
at the same time.
Door lock an ...
Checking the brake pedal free play
1) 0.08 – 0.18 in (2 – 5 mm)
Stop the engine and firmly depress the brake pedal several times. Lightly pull
the brake pedal up with one finger to check the free play with a force of less than ...
Important Safety Precautions
You’ll find many safety
recommendations throughout this
section, and throughout this manual.
The recommendations on this page
are the ones we consider to be the
most important.
Always Wear ...