Subaru Legacy: Heater operation
NOTE
● When the “” button or “” button is pressed the air conditioner compressor automatically operates to quickly defog the windshield. However the indicator on the air conditioner button will not illuminate. At the same time, the air inlet selection is automatically set to “outside air” mode.
● Warm air also comes out from the right and left air outlets. To stop warm airflow from these outlets, turn the corresponding wheel to the “” position.
Air inlet selection button
ON position (recirculation): Interior air is recirculated inside the vehicle. Press the air inlet button to the ON position. The indicator light will illuminate. Place this button in the ON posit ...Defrosting or defogging the windshield
To direct warm air to the windshield and front door windows: 1. Set the air inlet selection button to the OFF position. 2. Press the “” button. 3. Turn the temperature control dial all the way ...See also:
Cleaning the seat covers
Do not use microfiber cloths to clean
genuine leather, artificial leather or
Alcantara® covers. If used often, these can
damage the cover.
Observe the following when cleaning:
- clean g ...
Driving Experience Switch
The concept
The Driving Experience Switch can be used to
adjust the driving dynamics of the vehicle. For
this purpose various programs are available for
selection that are activated via the two ...
Engine oil
Vehicle equipment
All standard, country-specific and optional
equipment that is offered in the model series is
described in this chapter. Therefore, equipment
is also described that is not avai ...