Subaru Legacy: High beam indicator light - Warning and indicator lights - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: High beam indicator light

This light shows that the headlights are in the high beam mode.

This light shows that the headlights are in the high beam mode.

This indicator light also illuminates when the headlight flasher is operated.

    Turn signal indicator lights
    These lights show the operation of the turn signal or lane change signal. If the indicator lights do not blink or blink rapidly, the turn signal bulb may be burned out. Replace the bulb as soon a ...

    Cruise control indicator light
    The cruise control indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds. This light illuminates when the “CRUISE ...

    See also:

    Headlight Aiming
    The headlights were properly aimed when your vehicle was new. If you regularly carry heavy items in the trunk or pull a trailer, readjustment may be required. Adjustments should be done by y ...

    When the TRAC/VSC systems are operating
    If the vehicle is in danger of slipping or if any of the drive wheels spins, the slip indicator light flashes to indicate that the VSC/ TRAC systems are operating. ...

    Resuming the Set Speed
    When you push the CANCEL button, or tap the brake or clutch pedal, the system will remember the previously set cruising speed. To return to that speed, accelerate to above 25 mph (40 km/h), ...