Subaru Legacy: High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the secured clip of the washer tank. To make it easy to access the bulb, move the washer tank to the horizontal direction (left-hand side).
3. Disconnect the electrical connector from the bulb.
4. Remove the bulb from the headlight assembly by turning it counterclockwise.
5. Replace the bulb with new one. At this time, use care not to touch the bulb surface.
6. Reconnect the electrical connector.
7. To install the bulb to the headlight assembly, turn it clockwise until it clicks.
8. Install the air intake duct with clips (right-hand side).
9. Set the washer tank to the original place and secure it by clip (left-hand side).
Low beam light bulbs
1. Pull off the fender lining. For details, refer to “Pulling off the fender lining” F11- 7. 2. Remove the bulb cover, by turning it counterclockwise. 3. Disconnect the electrical connecto ...Front turn signal light
NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Turn over the protective cover of the engine compartment. 2 ...See also:
NISSAN Intelligent Key
WARNING:
- Radio waves could adversely affect electric medical equipment. Those who use
a pacemaker should contact the electric medical equipment manufacturer for the possible
influences before u ...
Check Fuel Cap Message
Your vehicle’s onboard diagnostic
system will detect a loose or missing
fuel fill cap as an evaporative system
leak. The first time a leak is detected
a ‘‘CHECK FUEL CAP’’ message ...
Drinking and driving
WARNING
Drinking and then driving is very dangerous. Alcohol in the bloodstream delays
your reaction and impairs your perception, judgment and attentiveness. If you drive
after drinking – even ...