Chrysler 200: High/Low Beam Switch
Push the multifunction lever away from you to switch the headlights to high beam. Pull the lever toward you, to switch the headlights back to low beam.
Lane Change Assist
Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then automatically turn off. ...Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released. NOTE: If the ...See also:
Operating tips
-When the shift selector is shifted to the R (Reverse) position, the display
screen automatically changes to the RearView Monitor mode. However, the radio can
be heard.
- It may take some time un ...
Technical specifications
Fuel consumption figures
...
Checking Engine Oil
It is a good idea to check the engine
oil level at each fuel fill. In order to
get an accurate reading, the vehicle
must be on level ground. The
engine oil dipstick handle is a yellow
loop. ...