Nissan Altima: HomeLink universal transceiver (if so equipped)
The HomeLink Universal Transceiver provides a convenient way to consolidate the functions of up to three individual hand-held transmitters into one built-in device.
HomeLink Universal Transceiver:
● Will operate most Radio Frequency (RF) devices such as garage doors, gates, home and office lighting, entry door locks and security systems.
● Is powered by your vehicle’s battery. No separate batteries are required. If the vehicle’s battery is discharged or is disconnected, HomeLink will retain all programming. Once the HomeLink Universal Transceiver is programmed, retain the original transmitter for future programming procedures (Example: new vehicle purchases). Upon sale of the vehicle, the programmed HomeLink Universal Transceiver buttons should be erased for security purposes. For additional information, refer to “Programming HomeLink ” later in this section.
WARNING
● Do not use the HomeLink Universal
Transceiver with any garage door
opener that lacks safety stop and reverse
features as required by federal
safety standards. (These standards became
effective for opener models
manufactured after April 1, 1982). A garage
door opener which cannot detect
an object in the path of a closing garage
door and then automatically stop and
reverse, does not meet current federal
safety standards. Using a garage door
opener without these features increases
the risk of serious injury or
death.
● During the programming procedure
your garage door or security gate will
open and close (if the transmitter is
within range). Make sure that people or
objects are clear of the garage door,
gate, etc. that you are programming.
● Your vehicle’s engine should be turned
off while programming the HomeLink
Universal Transceiver.
Trunk light
The light illuminates when the trunk lid is opened. When the trunk lid is closed, the light goes off. The light will go off after about 15 minutes if the trunk lid is left open, unless the ignition ...Programming HomeLink
1. To begin, press and hold the two outer HomeLink buttons (to clear the memory) until the indicator light 1 blinks (after 20 seconds). Release both buttons. 2. Position the end of the hand-held ...See also:
Making a call by entering a phone
number
1. Press the button on the
steering
wheel. A tone will sound.
2. Say: “Call” A . The system acknowledges
the command and announces the next set of
available commands.
Say: “Special Dia ...
Battery Load Management
The vehicle has Electric Power
Management (EPM) that estimates
the battery's temperature and state
of charge. It then adjusts the voltage
for best performance and extended
life of the batter ...
Audio System Lighting
You can use the instrument panel
brightness control knob to adjust the
illumination of the audio system. The audio system
illuminates when the parking lights
are on, even if the radio is turne ...