Subaru Legacy: How to preset stations
1. Press the “FM” or “AM” button to select FM1, FM2, FM3 or AM reception. 2. Press the “” or “” side of the “SEEK” button or tune the radio manually until the desired station frequency is displayed. 3. Press one of the preset buttons for more than 1.5 seconds to store the frequency. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory.
NOTE
● If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all stations stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset stations. . If a cell phone is placed near the radio, it may cause the radio to emit noise when the phone receives calls. This noise does not indicate a radio malfunction.
Station preset
Preset buttons ...Selecting preset stations
Presetting a station with a preset button allows you to select that station in a single operation. Up to six AM, FM1, FM2 and FM3 stations each may be preset. ...See also:
Fuel-Filler Lid and Cap
WARNING:
When removing the fuel cap, loosen the cap slightly and wait for any hissing
to stop. Then remove it:
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness if ingested.
...
Brake hoses and lines
Visually check for proper installation, chafing, cracks, deterioration and any
leakage. Replace any deteriorated or damaged parts immediately. ...
Useful information
This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differences ...