Subaru Legacy: How to re-stow bars - Roof rails with integrated crossbars (Outback) - Loading your vehicle - Driving tips - Subaru Legacy Owners ManualSubaru Legacy: How to re-stow bars

CAUTION

Do not use the bars as roof rails when the bars are stowed.

1. Pull out the crossbars from the roof rail holders by pulling up the covers.

1. Pull out the crossbars from the roof rail holders by pulling up the covers.

2. Slide the bars in the direction shown in the illustration.

2. Slide the bars in the direction shown in the illustration.

3. Install the bars into the holders.

3. Install the bars into the holders.
4. Make sure that the latches are fitted securely.

    How to use as crossbars
    CAUTION ● Do not raise the bar higher than necessary. The base of the bar may be damaged. ● Be careful not to contact the bars while sliding them. Otherwise, the bars may be scratched ...

    Trailer hitch (Outback — if equipped)
    WARNING ● Never exceed the maximum weight specified for the trailer hitch. Exceeding the maximum weight could cause an accident resulting in serious personal injuries. Permissible trailer w ...

    See also:

    Trailer Towing
    The Mazda6 is not designed for towing. Never tow a trailer with your Mazda6. ...

    Points To Remember
    NOTE: When the vehicle is stopped after a few miles (kilometers) of operation, you may observe vapor coming from the front of the engine compartment. This is normally a result of moisture from ...

    Operating tips
    ● When the shift selector is shifted to R (Reverse), the monitor screen automatically changes to the RearView Monitor mode. However, the radio can be heard. ● It may take some time unt ...