Nissan Maxima: Installing front license plate
Use the following steps to mount the front license plate:
(1) Make holes on the plastic finisher at the location mark (small dimple) using a 0.31 in (8 mm) drill. Apply light pressure to the drill.
Install the license plate holder using the two screws provided with the holder.
(2)- Mount the license plate using two M6- 14mm bolts.
License plate bolt tightening torque:
3.8 - 4.7 ft-lb (5.10 - 6.37 N·m)
Air conditioner specification label
The air conditioner specification label is affixed to the underside of the hood as shown. ...Vehicle loading information
WARNING: - It is extremely dangerous to ride in a cargo area inside a vehicle. In a collision, people riding in these areas are more likely to be seriously injured or killed. - Do not allow people ...See also:
Installing tire pressure warning valves and transmitters
When replacing tires or wheels, tire pressure warning valves and
transmitters must also be installed.
When new tire pressure warning valves and transmitters are
installed, new ID codes must be re ...
Current fuel consumption
Displays the current fuel
consumption.
You can check
whether you are currently driving
in an efficient and environmentally-
friendly manner.
Displaying the current fuel
consumption
1. &q ...
Installation with LATCH system
Type A
Widen the gap between the seat
cushion and seatback
slightly.
Latch the hooks of the lower
straps onto the LATCH anchors.
If the child restraint has a top
tether strap, the top te ...