Nissan Altima: NISSAN Intelligent Key™ battery discharge
If the battery of the Intelligent Key is almost discharged, the guide light A of the Intelligent Key port blinks and the indicator appears on the vehicle information display. See “Vehicle information display” in the “Instruments and controls” section.
In this case, inserting the Intelligent Key into the port B allows you to start the engine. Make sure the Intelligent Key is placed in the correct direction: The front side faces upward and the key ring side faces downward as illustrated.
To remove the Intelligent Key from the port, push the ignition switch to the LOCK position and pull the Intelligent Key out of the port C .
NOTE:
The Intelligent Key port does not charge the Intelligent Key battery. If you see the low battery indicator, replace the battery as soon as possible. See “Battery replacement” in the “Maintenance and do-ityourself” section.
CAUTION
● Never place anything except the Intelligent
Key in the Intelligent Key port. Doing
so may cause damage to the
equipment.
● Make sure the Intelligent Key is in the
correct direction when inserting it to
the Intelligent Key port. The engine may
not start if it is in the wrong direction..
● Remove the Intelligent Key from the
Intelligent Key port after the ignition
switch is pushed to the LOCK position.
Emergency engine shut off
To shut off the engine in an emergency situation while driving perform the following procedure: – Rapidly push the push-button ignition switch 3 consecutive times, or – Push and hold the push- ...NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key. If the engine fails to start using a registered key (for example, when interference ...See also:
Important Maintenance Precautions
If you have the required service
done but do not reset the display, or
reset the display without doing the
service, the system will not show the
correct maintenance intervals. This
can lead ...
Making a phone call
Making a phone call from the phone book
It is possible to select a phone number from the phonebook registered with the
invehicle equipment to make a phone call.
1. Press the OFF hook switch . Pres ...
Cleaning the seat belts
•► Use clean, lukewarm water and soap
solution.
Do not clean the seat belts using chemical
cleaning agents. Do not dry the seat belts
by warming them above 176 °F (80
°C) or
placin ...