Chrysler 200: Operation
When the shift lever is in the AutoStick position (below the DRIVE position), it can be moved from side to side.
This allows the driver to manually select the transmission gear being used. Moving the shift lever to the left (-) triggers a downshift and to the right (+) an upshift. The gear position will display in the instrument cluster on the transmission range indicator.
NOTE:
In AutoStick mode, the transmission will only
shift up or down when the driver moves the shift lever to
the right (+) or left (-), or as described below.
AutoStick is deactivated when the shift lever is moved from the AutoStick (+/-) position into the DRIVE position.
AutoStick — If Equipped
AutoStick is a driver-interactive feature providing manual shift control, giving you more control of the vehicle. AutoStick allows you to maximize engine braking, eliminate undesirable upshifts ...General Information
• You can start out, from a stop, in any gear except sixth. The system will ignore attempts to upshift at too low of a vehicle speed. • If a ratio other than first gear is selected, and the ...See also:
To Play the FM/AM Radio
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the
power/volume knob or ...
Checking the coolant level
Check the coolant level at each fuel stop.
1. Check the coolant level on the outside of the reservoir while the engine is
cool.
2. If the level is close to or lower than the “LOW” level mark ...
Door open indicator light
When any of the doors, the rear gate (Outback) or the trunk lid (Legacy) is not
fully closed, the door open indicator light illuminates. This function is effective
even if the ignition switch is ...