Toyota Camry: Positioning a floor jack
When raising your vehicle with a floor jack, position the jack correctly.
Improper placement may damage your vehicle or cause injury.
■ Front
■ Rear
2.5 L 4-cylinder (2AR-FE) engine
3.5 L V6 (2GR-FE) engine
CAUTION
■When raising your vehicle
Make sure to observe the following precautions to reduce the possibility of
death or serious injury:
●Lift up the vehicle using a floor jack
such as the one shown in the illustration.
●When using a floor jack, follow the instructions of the manual provided with
the jack.
●Do not use the jack that was supplied with your vehicle.
●Do not put any part of your body underneath the vehicle when it is supported
only by the floor jack.
●Always use floor jack and/or automotive jack stands on a solid, flat, level
surface.
●Do not start the engine while the vehicle is supported by the floor jack.
●Stop the vehicle on level, firm ground, firmly set the parking brake and shift
the shift lever to P.
●Make sure to set the floor jack properly at the jack point.
Raising the vehicle with an improperly positioned floor jack will damage
the vehicle and may cause the vehicle to fall off the floor jack.
●Do not raise the vehicle while someone is in the vehicle.
●When raising the vehicle, do not place any objects on top of or underneath
the floor jack.
Hood
Release the lock from the inside of the vehicle to open the hood. Pull the hood release lever. The hood will pop up slightly. Pull up the auxiliary catch lever and lift the hood. CAUTION & ...Engine compartment
2.5 L 4-cylinder (2AR-FE) engine Engine oil filler cap Engine oil level dipstick Brake fluid reservoir Fuse box Battery Radiator Electric cooling fans Condenser Engine coolant re ...See also:
Cargo Net
There is a cargo net for storing items on the side of the trunk. ...
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is
blown, you must reset your sunroof system as follows:
1. Turn the ignition switch to the ON position and close the sun ...
License Plate Lamp
The license plate lamps for this
vehicle are on the trunk lid.
To replace one of these bulbs:
1. Open the trunk. See Trunk for more information.
2. Push the end on either of the
lamp assembli ...