Nissan Maxima: Programming HomeLink for Canadian customers
Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds.
To program your hand-held transmitter to HomeLink, continue to press and hold the HomeLink button (see steps 2 - 4 under Programming HomeLink) while you press and repress (cycle) your hand-held transmitters every 2 seconds until the indicator light flashes rapidly (indicating successful programming).
NOTE:
When programming a garage door opener, etc., it is advised to unplug the device during the cycling process to prevent possible damage to the garage door opener components.
Programming HomeLink
1. To begin, press and hold the two outer HomeLink buttons (to clear the memory)
until the indicator light (1) blinks (after 20 seconds). Release both buttons.
2. Position the end of the hand-hel ...
Operating the HomeLink universal transceiver
The HomeLink Universal Transceiver (once programmed) may now be used to activate
the garage door, etc. To operate, simply press the appropriate programmed HomeLink
Universal Transceiver button. Th ...
See also:
Vehicle load capacity
Do not exceed the load limit of your vehicle shown as The combined weight of
occupants and cargo on the Tire and Loading Information label. Do not exceed the
number of occupants shown as Seating C ...
Heating and defrosting
To direct warm air toward the floor and the windshield:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial to the most comfor ...
Skip options
This function is used to remove a channel from the list of available channels.
Skipping a channel
1. Press OK/MENU.
2. Scroll to the Advanced settings menu.
3. Press OK/MENU to enter the Skip opti ...
