Volvo S60: Re-installing the wheel - Taking out the spare wheel - Changing a wheel - Wheels and tires - Volvo S60 Owners ManualVolvo S60: Re-installing the wheel

1. Clean the contact surfaces on the wheel and hub.

2. Lift the wheel and place it on the hub.

Tighten the lug nuts

Tighten the lug nuts

3. Install the wheel nuts and tighten handtight. Using the lug wrench, tighten crosswise until all nuts are snug.

4. Lower the vehicle to the ground and alternately tighten the bolts crosswise to 103 ft. lbs. (140 Nm).

5. Install the wheel cover (where applicable). The opening in the wheel cover for the tire's inflation valve must be positioned over the valve.

    Changing a wheel
    1. Apply the parking brake and put the gear selector in P. 2. Take out the jack*, lug wrench*, the towing eyelet and the wheel cover removal tool* stowed under the floor of the trunk. 3. Remove th ...

    Tire Pressure Monitoring System (TPMS)
    NOTE USA – FCC ID: KR5S122780002 This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, a ...

    See also:

    Tire Pressure Monitor System
    The Tire Pressure Monitor System (TPMS) uses radio and sensor technology to check tire pressure levels. The TPMS sensors monitor the air pressure in your tires and transmit tire pressure readings to a ...

    Engine coolant
    The coolant level is satisfactory if it is between the “F” and “L” lines on the reservoir when the engine is cold. Reservoir cap “F” line “L” line If the level is on or ...

    Center console box (rear)
    The center console box has a two-layer structure consisting of an upper compartment and a lower compartment. Upper compartment 1) Upper compartment lock release Pull up the upper compartment l ...