Buick LaCrosse: Rear Vision Camera (RVC) - Object Detection Systems - Driving and Operating - Buick LaCrosse Owners ManualBuick LaCrosse: Rear Vision Camera (RVC)

This vehicle may have an RVC system. Read this entire section before using it.

The RVC system can assist the driver when backing up by displaying a view of the area behind the vehicle.

WARNING!
The RVC system does not display pedestrians, bicyclists, animals, or any other object located outside the camera's field of view, below the bumper, or under the vehicle.
Do not back the vehicle using only the RVC screen or by using the screen during longer, higher speed backing maneuvers, or where there could be cross-traffic. Perceived distances may be different from actual distances.
Failure to use proper care before backing may result in injury, death, or vehicle damage. Always check before backing by checking behind and around the vehicle.

An image appears on the navigation screen with the message Check Surroundings for Safety when the vehicle is shifted into R (Reverse).

The navigation screen goes to the previous screen after approximately 10 seconds once the vehicle is shifted out of R (Reverse).

To cancel the delay, do one of the following:

• Press a hard key on the navigation system.

• Shift into P (Park).

• Reach a vehicle speed of 8 km/h (5 mph).

FCC Information
See Radio Frequency Statement for information regarding Part 15 of the Federal Communications Commission (FCC) rules and Industry Canada Standards RSS-GEN/210/220/310. ...

Turning the Rear Vision Camera System On or Off
To turn the RVC system on or off: 1. Shift into P (Park). 2. Press the CONFIG button to enter the configure menu options. 3. Select Display. 4. Select Rear Camera Options. 5. Select Camera. ...

See also:

Securing cargo
Lashing eyes in the cargo area Lashing eyes in the cargo area To secure the cargo, there are four lashing eyes in the cargo area Securing cargo ▷ Smaller and lighter items: secure with r ...

Shift Lock Release
This allows you to move the shift lever out of Park if the normal method of pushing on the brake pedal and pressing the release button does not work. 1. Set the parking brake. 2. Remove the ...

Airflow mode selection button
Select the desired airflow mode by pressing the airflow mode selection button. The selected airflow mode is shown on the display. There are four airflow modes that activate the following air outl ...