Buick LaCrosse: Remaining Oil Life - Driver Information Center (DIC) - Information Displays - Instruments and Controls - Buick LaCrosse Owners ManualBuick LaCrosse: Remaining Oil Life

This display shows an estimate of the oil's remaining useful life.

If REMAINING OIL LIFE 99% is displayed, that means 99% of the current oil life remains.

When the remaining oil life is low, the CHANGE ENGINE OIL SOON message will appear on the display.

See Engine Oil Messages. The oil should be changed as soon as possible. See Engine Oil. In addition to the engine oil life system monitoring the oil life, additional maintenance is recommended in the Maintenance Schedule in this manual. See Maintenance Schedule for more information.

Remember, the Oil Life display must be reset after each oil change. It will not reset itself. Also, be careful not to reset the Oil Life display accidentally at any time other than when the oil has just been changed.

It cannot be reset accurately until the next oil change. To reset the engine oil life system, press SET/CLR while the Oil Life display is active. See Engine Oil Life System.

    Jump Start (eAssist Only)
    This display allows for on-board jump starting of the vehicle. See “Jump Starting (On-board with eAssist Only)” for more information. ...

    Battery Voltage
    This display, available on some vehicles, shows the current battery voltage. If the voltage is in the normal range, the value will display. For example, the display may read Battery Voltage 1 ...

    See also:

    Key memory: door mirrors and driver's seat
    The position of the side door mirrors and power driver's seat are stored in the remote keys when the vehicle is locked. The next time the driver's door is unlocked with the same remote key ...

    Buying New Tires
    GM has developed and matched specific tires for the vehicle. The original equipment tires installed were designed to meet General Motors Tire Performance Criteria Specification (TPC Spec) system rati ...

    Installing front license plate
    To mount the front license plate, attach the license plate bracket 1 to the plastic finisher at the location marks (small dimples) using the two 6 mm screws provided. ...