Subaru Legacy: Removing and reinstalling clips
Removing clips
There are several types of clips used for your vehicle
Type A clips
1. Turn the clips counterclockwise using a flat-head screwdriver until the center
portion of the clip is raised.
2. Remove the clips with a flat-head screwdriver using leverage.
Type B clips
1. Pull out the center portion of the clip using a flat-head screwdriver as shown
in the illustration.
2. Pull the protruded center portion to remove the entire body of the clip.
Type C clips
1. Turn the clip counterclockwise using a Phillips screwdriver until the center
portion of the clip is raised.
2. Remove the entire clip by pulling it up.
Reinstalling clips
Type A clips
Type B clips
Type C clips
Insert the clip without the center portion first and then push the center portion of the clip into the hole.
Maintenance tips
Some clips and fender linings must be removed before replacing the air cleaner elements or specific bulbs. ...Removing air intake duct
Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct. Refer to “Type A clips” F11-5. ...See also:
Jump starting
If jump starting is necessary, see “Jump starting”
in the “In case of emergency” section of this
manual. If the engine does not start by jump
starting, the battery may have to be replaced.
...
Setting a speed
Once ACC has been put in standby mode, use the
or
buttons to store (set) the vehicle's
current speed. This puts the system in active mode. The set speed, for example 55
mph, is shown in th ...
Cleaning genuine wood and trim
elements
•► Wipe the wooden trim and trim pieces with
a damp, lint-free cloth, e.g. a microfiber
cloth.
•► Heavy soiling: use car care and cleaning
products recommended and approved by
...