Subaru Legacy: Scan
The scan mode lets you listen to the first 10 seconds of each track/file in succession. Press the “SCAN” button to start scanning upward beginning with the track/ file(s) following the currently selected one. After all track/file(s) in the disk/folder have been scanned, normal playback will be resumed. To cancel the scan mode, press the “SCAN” button again.
NOTE
The scan mode will be cancelled if you perform any of the following steps.
● Press the “RPT” button
● Press the “RDM” button
● Press the “RPT/RDM” button
● Turn the “TUNE/TRACK/CH” dial
● Press the “” or “”
side of the “FOLDER” button
● Press the “” button
● Press the “” or “”
side of the “SEEK” button
● Press the disc select button
● Select the radio or AUX mode
● Press the “LOAD” button when there is free space in the CD magazine
● Turn off the power of the audio
equipment
● Turn the ignition switch to the “LOCK” position
Random playback
Type A audio Type B audio To play back a track/file(s) at random, press the “RPT/RDM” button for 0.5 second or longer (type A audio) or press the “RDM” button (type B audio). ● ...Display selection
If you press the “TEXT” button during playback, the indication will change to the next one in the following sequence. For CD-DA: ...See also:
Suggested up-shift speeds
The following are suggested vehicle speeds for
shifting into a higher gear. These suggestions
relate to fuel economy and vehicle performance.
Actual upshift speeds will vary according to road
cond ...
Overall evaluation
This function is shown if you have stored at
least one lap and stopped the RACETIMER.
•► Press on the steering wheel
to select the AMG menu.
•► Press the button repeatedly unti ...
ATA (Anti-Theft Alarm system)
A visual and audible alarm is triggered if the
alarm system is armed and you open:
- a door
- the vehicle with the mechanical key
- the trunk lid/tailgate
- the hood
The alarm is not s ...