Chrysler 200: Seat Belts - Safety Checks You Should Make Inside The Vehicle - Safety Tips - Things to know before starting your vehicle - Chrysler 200 Owners ManualChrysler 200: Seat Belts

Inspect the belt system periodically, checking for cuts, frays, and loose parts. Damaged parts must be replaced immediately. Do not disassemble or modify the system.

Front seat belt assemblies must be replaced after a collision. Rear seat belt assemblies must be replaced after a collision if they have been damaged (i.e., bent retractor, torn webbing, etc.). If there is any question regarding belt or retractor condition, replace the belt.

    Air Bag Warning Light
    The light should come on and remain on for four to eight seconds as a bulb check when the ignition switch is first turned ON. If the light is not lit during starting, see your authorized dealer. ...

    See also:

    Oil volume
    ...

    When to Add Engine Oil
    If the oil is below the cross-hatched area at the tip of the dipstick, add 1 L (1 qt) of the recommended oil and then recheck the level. See “Selecting the Right Engine Oil” in this section for ...

    System self-test
    After you have switched on the ignition, the system carries out a self-diagnosis. WARNING A malfunction in the system has been detected if one of the following conditions occurs:  - ...