Subaru Legacy: Seat heater (if equipped) - Seat, seatbelt and SRS airbags - Subaru Legacy Owners ManualSubaru Legacy: Seat heater (if equipped)

1) HIGH – Rapid heating

1) HIGH – Rapid heating
2) LOW – Normal heating
3) OFF – Off
A) Left-hand side
B) Right-hand side

The seat heater operates when the ignition switch is either in the “Acc” or “ON” position.

To turn on the seat heater, press the “LOW” or “HIGH” position on the switch, as desired, depending on the temperature. Selecting the “HIGH” position will cause the seat to heat up quicker.

To turn off the seat heater, slightly press the opposite side of the current position. The indicator located on the switch illuminates when the seat heater is in operation. When the vehicle’s interior is warmed enough or before you leave the vehicle, be sure to turn the switch off.

CAUTION

● There is a possibility that people with delicate skin may suffer slight burns even at low temperatures if they use the seat heater for a long period of time. When using the heater, always be sure to warn the persons concerned.

● Do not put anything on the seat which insulates against heat, such as a blanket, cushion, or similar items. This may cause the seat heater to overheat.

NOTE

Use of the seat heater for a long period of time while the engine is not running can cause battery discharge.

    Head restraint adjustment
    1) Head restraint 2) Release button Both the driver’s seat and the front passenger’s seat are equipped with head restraints. The head restraint should be adjusted so that the center of the ...

    Rear seats
    WARNING Seatbelts provide maximum restraint when the occupant sits well back and upright in the seat. Do not put cushions or any other materials between occupants and seatbacks or seat cushions ...

    See also:

    Vehicle equipment
    All standard, country-specific and optional equipment that is offered in the model series is described in this chapter. Therefore, equipment is also described that is not available in a vehicle, ...

    Ignition off
    Automatic transmission: press the Start/Stop button again, and do not press on the brake pedal at the same time. Manual-shift transmission: press the Start/Stop button again, and do not press o ...

    Operating DAC
    Certain settings can be made from the menu system controlled from the center instrument panel. The current system status can be checked on the trip computer’s display by using the buttons on th ...