Mazda Mazda6: Starting the Engine
With advanced key
Refer to “Starting the engine” for information on how to start the engine.
NOTE:
Engine-starting is controlled by the spark ignition system.
This system meets all Canadian Interference- Causing Equipment Standard requirements regulating the impulse electrical field strength of radio noise.
1. Occupants should fasten their seat belts.
2. Make sure the parking brake is on.
3. Depress the brake pedal.
4. (Manual transaxle).
Depress the clutch pedal all the way and shift into neutral.
Keep the clutch pedal depressed while cranking the engine.
(Automatic transaxle).
Put the vehicle in park (P). If you must restart the engine while the vehicle is moving, shift into neutral (N).
NOTE:
(Manual transaxle).
The starter will not operate unless the clutch is depressed sufficiently.
(Automatic transaxle).
The starter will not operate if the shift lever is not in P or N.
5. Turn the ignition switch to the START position and hold (up to 10 seconds at a time) until the engine starts.
CAUTION:
Do not try the starter for more than 10 seconds at a time. If the engine stalls or fails to start, wait 10 seconds before trying again. Otherwise, you may damage the starter and drain the battery.
6. After starting the engine, let it idle for about 10 seconds.
NOTE:
- In extremely cold weather or after the vehicle has not been driven in several days, let the engine warm up without operating the accelerator.
- Whether the engine is cold or warm, it should be started without use of the accelerator.
- If the engine does not start the first time, refer to Starting a Flooded Engine under Emergency Starting. If the engine still does not start, have your vehicle inspected by an Authorized Mazda Dealer.
Ignition Switch
With advanced key Refer to “Starting the engine” for information on how to use the ignition switch. Ignition Switch Positions (Without Advanced Key) LOCK The steering wheel locks to protect ...Brake System
Foot Brake Your Mazda has power-assisted brakes that adjust automatically through normal use. Should power-assist fail, you can stop by applying greater force than normal to the brake pedal. But ...See also:
Tire Pressure
The display will show a vehicle with
the approximate pressures of all
four tires. Tire pressure is displayed
in either kilopascal (kPa) or pounds
per square inch (psi). See Tire
Pressure Mon ...
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer System will not allow the engine to start without
the use of a registered key.
If the engine fails to start using a registered key (for example, when interference
i ...
Battery Power Protection
The battery saver feature is designed to protect the vehicle's battery.
To prevent battery discharge while driving, the following systems are reduced automatically in two stages and then turned off:
...