Ford Fusion: Telephone setup - Telephone - Ford Fusion Owners manualFord Fusion: Telephone setup

Requirements for cradleconnection

Your phone must be fitted in a mobilephone holder before it can be used as acradle phone with your handsfree/voicecontrol system. You will be able topurchase the correct holder for yourphone from your dealer.

Placing your phone in thecradle

Note: Your phone must be fitted in amobile phone holder to allow you toconnect the phone to the cradle.

Connect your phone to the cradle.

1. Place the base of the phone in thecradle connection.

Note: Make sure that the phone ispushed fully rearwards in the cradle.

2. Push the phone downwards until aclick is heard.

Note: The connection to the system willbe displayed on your phone.

Note: The connection to the system willbe displayed on your phone.

Phonebook

After start up access to the phonebookcan be delayed for up to two minutes.

Phonebook categories

Depending on your phonebook entry,different categories can be displayed inthe audio or navigation unit.

For example:

Note: Entries may be displayed withouta category attachment.

Note: Entries may be displayed withouta category attachment.

The category can also be indicated as anicon:

Mobile

Phone

Home

Mobile

Office

Home

Fax

Office

Making a phone an activephone

Fax

Making a phone an activephone

When using the system for the first time,no phone is connected to the system.

After switching on the ignition the cradlephone and the Bluetooth phone arerecognized differently by the system.

Bluetooth phone

After bonding a Bluetooth phone to thesystem, this becomes the active phone.

For further information refer to the phonemenu.

However, in some cases the Bluetoothphone has to be activated by pressingthe appropriate station button on theaudio or navigation unit.

Turning the ignition back on again, the lastactive phone is picked up by the system.

Bond another Bluetooth phone

Note: Before another Bluetooth phonecan be bonded, the existing activeBluetooth connection has to bedeactivated by the mobile phone.

Bond a new Bluetooth phone asdescribed in the requirements for aBluetooth connection.

Phones stored in the system areaccessible by using the phone list on theaudio or navigation unit.

Note: If six (five Bluetooth phones forcradle phone system) Bluetooth phoneshave been bonded, one of these has tobe deleted in order to bond a new phone.

Cradle phone

With your phone fitted in the mobile phonecradle this does not automatically becomethe active phone.

In these cases refer to Changing theactive phone in the appropriate sectionwhich describes the system fitted to yourvehicle.

    General information
    This section describes the functions andfeatures of the Bluetooth mobile phoneand voice control system. The section covers the followingvariations: • a mobile phone with a mobile phonecradle witho ...

    Bluetooth setup
    Before you can use your telephone withyour vehicle it must be bonded to thevehicle telephone system. Handling of phones A phone can be connected to the vehiclesystem by using either a cradleconnecti ...

    See also:

    Scheduled Maintenance (USA, Canada, and Puerto Rico)
    Follow Schedule 1 if the vehicle is operated mainly where none of the following conditions apply. - Repeated short-distance driving. - Driving in dusty conditions. - Driving with extended use of ...

    Brake Fluid
    The brake master cylinder and, on manual transmission vehicles, the clutch hydraulic system use the same reservoir. See Engine Compartment Overview  for the location of the reservoir. The reser ...

    Operating DAC
    Certain settings can be made from the menu system controlled from the center instrument panel. The current system status can be checked on the trip computer’s display by using the buttons on th ...