Dodge Avenger: Tilt/telescoping steering column - Understanding the features of your vehicle - Dodge Avenger Owners ManualDodge Avenger: Tilt/telescoping steering column

This feature allows you to tilt the steering columnupward or downward. It also allows you to lengthen orshorten the steering column. The tilt/telescoping controlhandle is located below the steering wheel at the end ofthe steering column.

Tilt/Telescoping Steering

Tilt/Telescoping Steering Wheel

To unlock the steering column, pull the control handleoutward. To tilt the steering column, move the steeringwheel upward or downward as desired. To lengthen orshorten the steering column, pull the steering wheeloutward or push it inward as desired. To lock the steeringcolumn in position, push the control handle inward untilfully engaged.

WARNING:

Do not adjust the steering column while driving.

Adjusting the steering column while driving or drivingwith the steering column unlocked, could causethe driver to lose control of the vehicle. Be sure thesteering column is locked before driving your vehicle.

Failure to follow this warning may result inserious injury or death.

    Windshield wipers and washers
    The wipers and washers are operated by a switchon the control lever. The lever is located on theright side of the steering column. Windshield Wiper/Washer Lever Rotate the end of the lever t ...

    Electronic speed control
    When engaged, the Electronic Speed Control takes overthe accelerator operation at speeds greater than 25 mph(40 km/h). The Electronic Speed Control lever is located on the rightside of the steering ...

    See also:

    Adjusting The Seat Up Or Down
    The height of the seats can be adjusted up or down. Pull upward or push downward on the rear of the seat switch, the seat will move in the direction of the switch. Release the switch when the de ...

    NEUTRAL
    Use this range when vehicle is standing for prolonged periods with engine running. The engine may be started in this range. Set the parking brake and shift the transmission into PARK if you must ...

    Place a Call Using a Stored Number
    1. Push . System responds: “OnStar ready.”. 2. Say “Call <name tag>.” System responds: “OK, calling <name tag>.” ...