Buick LaCrosse: Timer
This display can be used as a timer.
To start the timer, press SET/CLR while Timer is displayed. The display will show the amount of time that has passed since the timer was last reset, not including time the ignition is off. Time will continue to be counted as long as the ignition is on, even if another display is being shown on the DIC. The timer will record up to 99 hours, 59 minutes, and 59 seconds (99:59:59) after which the display will return to zero.
To stop the timer, press SET/CLR briefly while Timer is displayed. To reset the timer to zero, press and hold SET/CLR.
Average Vehicle Speed
This display shows the average
speed of the vehicle in miles per
hour (mph) or kilometers per
hour (km/h). This average is
calculated based on the various
vehicle speeds recorded since the
...
Navigation
This display is used for the OnStar
or Navigation System Turn-by-Turn
guidance. See OnStar Overview or the navigation manual,
if the vehicle has navigation, for
more information. ...
See also:
Doing Your Own Service Work
WARNING
You can be injured and the vehicle could be damaged if you try to do service work on a vehicle without knowing enough about it.
► Be sure you have sufficient knowledge, experience, ...
Making Turns
Notice:
Making very sharp turns
while trailering could cause the
trailer to come in contact with the
vehicle. The vehicle could be
damaged. Avoid making very
sharp turns while trailering.
...
Starting a diesel engine
Cold or hot engine
All vehicles
Note: When the temperature is below-15ºC (5ºF), you may need to crank theengine for up to 25 seconds. If youconsistently operate the vehicle in suchtemperat ...
