Chrysler 200: To Exit Remote Start Mode Without Driving The Vehicle
Press and release the REMOTE START button one time or allow the engine to run for the entire 15 minute cycle.
NOTE:
To avoid unintentional shut downs, the system
will disable the one-time press of the Remote Start button
for two seconds after receiving a valid remote start
request.
To Enter Remote Start Mode
Press and release the REMOTE START button on the RKE transmitter twice within five seconds. The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will ...To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15 minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then insert the key int ...See also:
Folding down the rear seat backrests
The rear seat backrests are split and can be folded down together
or separately
1. Pull the release control handle(s).
2. Fold the backrest forward. Adjust the center seat head restraint if nece ...
Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as po ...
Removing and installing the clips
The luggage trim cover and trunk panel cover clip
Removing
Installing
The fender liner clip
Installing
CAUTION
■Replacing light bulbs
●Turn off the lights. Do not attempt ...