Buick LaCrosse: Turning the System On and Off
The URPA system can be turned on and off using the park assist button located next to the shift lever.
The LED next to the park assist button lights up when the system is on and turns off when it has been disabled.
When the system is off, PARK ASSIST OFF displays on the Driver Information Center (DIC). The message disappears after a short period of time.
URPA defaults to the on setting each time the vehicle is started.
How the System Works
URPA comes on automatically when
the shift lever is moved into
R (Reverse). A single tone sounds
to indicate the system is working.
URPA operates only at speeds less
than 8 km/h (5 mph).
An ...
When the System Does Not
Seem to Work Properly
The following messages may be
displayed on the DIC:
SERVICE PARK ASSIST: If this
message occurs, take the vehicle to
your dealer to repair the system.
PARK ASSIST OFF: If the URPA
system doe ...
See also:
Wheels
If a wheel is bent, cracked or heavily corroded, it should be
replaced. Otherwise, the tire may separate from the wheel or
cause a loss of handling control. ...
“up” and “down” switch
With radio mode selected
Press the switch to the “” or “”
side briefly to skip to a preset channel. Press the switch to the “”
or “” side for more than 0.5 second
to seek the ...
Overview of transmission positions
The DIRECT SELECT lever is on the right of the
steering column.
P Park position with parking lock
R Reverse gear
N Neutral
D Drive
The DIRECT SELECT lever always returns
to its ori ...