Subaru Legacy: When you do not tow a trailer
● Remove the ball mount from the hitch receiver tube and insert the receiver
cover onto the hitch receiver tube.
● Place the dust cap over the four-pin connector of the hitch wire harness to protect
against possible damage.
● Occasionally lubricate terminals of the four-pin connector using terminal grease.
Connecting a trailer
1. Remove the receiver cover from the hitch receiver tube. Then insert the ball mount into the hitch receiver tube. 2. Insert the hitch pin into the hole on the hitch receiver tube so that the ...Trailer towing
Your vehicle is designed and intended to be used primarily as a passenger-carrying vehicle. Towing a trailer puts additional loads on your vehicle’s engine, drivetrain, brakes, tires and suspens ...See also:
Cleaning the interior
Seat belts
WARNINGS:
Do not use abrasives, or chemicalsolvents to clean them.
Do not allow moisture to penetratethe seat belt retractor mechanism.
Clean the seat belts with interior cleaneror wate ...
Defogging logic
To reduce the probability of fogging up the inside of the windshield, the air
intake is controlled automatically according to certain conditions such as
or
position. To cancel or return the defo ...
Window Fogging
Interior fogging on the windshield can be quickly removed
by turning the mode selector to Defrost. The Mix
mode can be used to maintain a clear windshield and
provide sufficient heating. If side ...