Subaru Legacy: Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Open the cover
2) Pull down the wiper blade
2. Remove the wiper blade assembly by opening the cover and pulling it down in
the direction shown in the illustration.
3. Install the wiper blade assembly to the wiper arm. Make sure that it locks in
place.
4. Hold the wiper arm by hand and slowly lower it in position.
Replacement of wiper blades
Grease, wax, insects, or other materials on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass. If you cannot remove the streaks after operating the wind ...Windshield wiper blade rubber
1) Support 1. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the support. 1) Metal spines 2. If the new blade rubber is not ...See also:
Tilting The Seat Up Or Down
The angle of the seat cushion can be adjusted in four
directions. Pull upward or push downward on the front
or rear of the seat switch, the front or rear of the seat
cushion will move in the dir ...
When driving
Driving, stopping and safe-driving information. ...
Anti-lock Braking System (ABS)
WARNING:
- The Anti-lock Braking System (ABS) is a sophisticated device, but it cannot
prevent accidents resulting from careless or dangerous driving techniques. It can
help maintain vehicle cont ...