Subaru Legacy: Canceling the function for meter/gauge needle movement upon turning on the ignition switch
It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition switch to the “LOCK” or “Acc” position.
2. Press the trip knob to show “ ” or “ ” on the trip meter display
The display can be switched as shown in the following illustration by pressing the trip knob.
3. To change the current setting, press the trip knob for at least 2 seconds.
: Activated : Deactivated
NOTE
● Your vehicle’s initial movement setting of the meter/gauge needles has been
set for activation “ ” at the time of shipment from the factory.
● It is not possible to change the initial movement setting of the meter/gauge needles
when the ignition switch is in the “ON” position. Change the setting when the ignition
switch is in the “LOCK” or “Acc” position.
Combination meter illumination
When the ignition switch is turned to the “ON” position, the various parts of the combination meter are illuminated in the following sequence. 1. Warning lights, indicator lights, meter needles ...Speedometer
The speedometer shows the vehicle speed. ...See also:
Forward-facing child restraint installation
using LATCH
Refer to all Warnings and Cautions in the “Child
Safety” and “Child Restraint” sections before installing
a child restraint.
Follow these steps to install a forward-facing
child restrain ...
Auto Window Up With Anti-Pinch Protection — If Equipped
Lift the window switch fully upward to the second
detent, release, and the window will go up automatically.
To cancel the Auto Up movement, operate the switch
either in the up or down direction a ...
Normal maintenance schedule
Engine control
system
Chassis and body
Chassis and body
Chart symbols:
I - Inspect these items and their related parts. If necessary, correct, clean,
refill, adjust or replace.
R - Replace ...