Ford Fusion: General information - Wheels and tyres - Ford Fusion Owners manualFord Fusion: General information

CAUTIONS:

Use only approved wheel and tyresizes. Using other sizes coulddamage the vehicle and will makethe National Type Approval invalid.

If you change the diameter of thetyres from that fitted at the factory,the speedometer may not displaythe correct speed. Take the vehicle toyour dealer to have the enginemanagement system reprogrammed.

A decal with tyre pressure data is locatedin the driver’s door opening at the B-pillar.

Check and set the tyre pressure at theambient temperature in which you areintending to drive the vehicle and whenthe tyres are cold.

Tyre pressures

WARNING:

If the vehicle is used with a roof loador is fully laden the tyres must be setto the full load tyre pressuresettings.

Driving at normal tyre pressures willimprove ride comfort; however it will alterthe driving characteristics and fuelconsumption of the vehicle.

For optimum dynamic performance therecommended tyre pressure setting is2.4 bar (35 psi) front and 2.2 bar (32 psi)rear.

    Changing a road wheel
    Spare wheel If the spare wheel differs from the otherfitted wheels, these rules must befollowed: WARNINGS: Do not exceed 80 km/h (50 mph). Drive the shortest possibledistances before having the sp ...

    See also:

    Searching for contacts
    Searching for contacts using the text wheel List of characters Switch between character entry modes (see the following table) Phone book (list of contacts) To search for or edit a contact ...

    Canceling the function for meter/gauge needle movement upon turning on the ignition switch
    It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position. 1. Turn the ignition swi ...

    Air bag warning light
    The purpose of air bag warning light in your instrument panel is to alert you of a potential problem with your air bag - Supplemental Restraint System (SRS). When the ignition switch is turned ON ...