Nissan Maxima: Programming trouble-diagnosis
If the HomeLink does not quickly learn the handheld transmitter information:
- replace the hand-held transmitter batteries with new batteries.
- position the hand-held transmitter with its battery area facing away from the HomeLink surface.
- press and hold both the HomeLink and hand-held transmitter buttons without interruption.
- position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position keeping the indicator light in view at all times.
If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this manual.
Operating the HomeLink universal transceiver
The HomeLink Universal Transceiver (once programmed) may now be used to activate
the garage door, etc. To operate, simply press the appropriate programmed HomeLink
Universal Transceiver button. Th ...
Clearing the programmed information
Individual buttons cannot be cleared. However, to clear all programming, press
and hold the two outside buttons and release when the indicator light begins to
flash (approximately 20 seconds). ...
See also:
General Information
• You can start out, from a stop, in any gear except sixth.
The system will ignore attempts to upshift at too low
of a vehicle speed.
• If a ratio other than first gear is selected, and the
...
Gear Ranges
DO NOT race the engine when shifting from PARK or
NEUTRAL into another gear range. ...
Automatic Transmission
The shift lever must be in the PARK or NEUTRAL
position before you can start the engine. Apply the brakes
before shifting to any driving gear.
NOTE:
The ignition switch must be in the ON positio ...