Nissan Maxima: Clearing the programmed information - Instruments and controls - Nissan Maxima Owners ManualNissan Maxima: Clearing the programmed information

Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds).

    Programming trouble-diagnosis
    If the HomeLink does not quickly learn the handheld transmitter information: - replace the hand-held transmitter batteries with new batteries. - position the hand-held transmitter with its battery a ...

    Reprogramming a single HomeLink button
    To reprogram a HomeLink Universal Transceiver button, complete the following. 1. Press and hold the desired HomeLink button. Do not release the button until step 4 has been completed. 2. When the i ...

    See also:

    Manual transmission
    Switching off the engine 1. With the vehicle at a standstill, press the Start/Stop button. 2. Shift into first gear or reverse. 3. Set the parking brake. ...

    Troubleshooting guide
    The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each solution i ...

    Recalibrating TPMS (Canadian models only)
    In certain cases, it may be necessary to recalibrate TPMS to conform to Volvo's recommended tire inflation pressures (see the inflation pressure table on page 275), for example, if higher infl ...