Nissan Maxima: Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver button, complete the following.
1. Press and hold the desired HomeLink button.
Do not release the button until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface.
3. Press and hold the hand-held transmitter button.
4. The HomeLink indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons.
The HomeLink Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink button that was just programmed. This procedure will not affect any other programmed HomeLink buttons.
Clearing the programmed information
Individual buttons cannot be cleared. However, to clear all programming, press
and hold the two outside buttons and release when the indicator light begins to
flash (approximately 20 seconds). ...
If your vehicle is stolen
If your vehicle is stolen, you should change the codes of any non-rolling code
device that has been programmed into HomeLink. Consult the Owners Manual of each
device or call the manufacturer or d ...
See also:
Engine Coolant
The cooling system in the vehicle is
filled with DEX-COOLВ® engine
coolant mixture. See Recommended
Fluids and Lubricants
and Maintenance Schedule for more information.
The following explains ...
Audio control buttons (if equipped)
Type A audio
Type B audio
These buttons are located on the spokes of the steering wheel. They allow the
driver to control audio functions without taking his/her hands off the steering
wheel. ...
Exterior and interior lights
Coupe
1. Mirror-mounted turn signal light
(if so equipped)
2. Interior light
3. Map light
4. Headlamp assembly
5. Fog light (if so equipped)
6. Step light
7. High-mount stoplight
8. Trunk ...