Toyota Camry: Certification for the Blind Spot Monitor
FCC ID: OAYBSDTX
This device complies with part 15 of the FCC Rules. Operation is subject to the following three conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
(3) This device may only work when the vehicle is in operation pursuant to § 15.252 (a) (4).
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
CAUTION
■Cautions regarding the use of the system
The driver is solely responsible for safe driving. Always drive safely, taking
care to observe your surroundings.
The Blind Spot Monitor is a supplementary system which alerts the driver
that a vehicle is present in the blind spot. Do not overly rely on the Blind
Spot
Monitor. The system cannot judge if it is safe to change lanes, therefore over
reliance could cause an accident resulting in death or serious injury. According
to conditions, the system may not function correctly. Therefore the
driver’s own visual confirmation of safety is necessary.
■Handling the radar sensor
One Blind Spot Monitor is installed inside the left and right side of the
vehicle
rear bumper respectively. Observe the following to ensure the Blind Spot
Monitor can function correctly.
●Keep the sensor and its surrounding
area on the bumper clean at all times.
●Do not subject the sensor or surrounding area on the bumper to a strong
impact. If the sensor moves even slightly off position, the system may
malfunction
and vehicles that enter the detection area may not be detected. If
the sensor or surrounding area is subject to a strong impact, always have
the area inspected by your Toyota dealer.
●Do not disassemble the sensor.
●Do not attach accessories or stickers to the sensor or surrounding area on
the bumper.
●Do not modify the sensor or surrounding area on the bumper.
●Do not paint the sensor or surrounding area on the bumper.
When there is a malfunction in the system
If a system malfunction is detected due to any of the following reasons, warning lights will turn on: ●There is a malfunction with the sensors ●The sensors have become dirty ●Th ...See also:
Snow Tires
Some areas of the country require the use of snow tires
during the winter. All season tires can be identified by the
M+S designation on the tire sidewall.
If you need snow tires, select tires equ ...
Lower Anchor and Top Tether
Anchor Locations
Rear Seat
(Top Tether Anchor): Seating
positions with top tether anchors.
(Lower Anchor): Seating
positions with two lower anchors.
To assist in locating the lower
anchors, each rear an ...
At a glance
1. Function bar
2. Route section with traffic obstruction
3. Traffic sign for traffic obstruction
4. Planned route
5. Current location
6. Upper status field
7. Lower status field
Lines in the ...