Nissan Maxima: Control buttons
The control buttons for the Bluetooth Hands- Free Phone System are located on the steering wheel.
PHONE/SEND
Press the button to initiate a VR session or answer an incoming call.
You can also use the button to interrupt the system feedback and give a command at once. See List of voice commands and During a call in this section for more information.
PHONE/END
While the voice recognition system is active, press and hold the button for 5 seconds to quit the voice recognition system at any time.
TUNING SWITCH
While using the voice recognition system, tilt the tuning switch up or down to manually control the phone system (if so equipped).
Using the system
The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to ve ...Getting started
The following procedures will help you get started using the Bluetooth Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to List of voice commands in thi ...See also:
Automatic cruise control cancelation
Cruise control will stop maintaining the vehicle speed in any of the
following
situations.
●Actual vehicle speed falls more than approximately 10 mph (16 km/h)
below the preset vehicle sp ...
Disc Scan
When you press the SCAN side of
the SCAN/A. SEL bar repeatedly
until you see D-SCAN in the center
display, or push the interface
selector to the right, the first track of
the current disc pl ...
Cruise control can be set when
●The shift lever is in the D or range 4 or higher of S has been selected.
●Range 4 or higher has been selected by using the paddle shift.
(vehicles with paddle shift switch).
●Veh ...